Electrical short circuits are bound to happen for various reasons, chief among them being that the electrical wiring in question happens to be antique and old. And it is always better to call in a professional to handle the repairs and get it fixed up. But if you are keen to check it out, you can check out the rest of the post. Just make sure that you wear appropriate safety clothes when you check out the short circuit and the electrical fuses, wiring, etc.
Overloading
One of the reasons you could blow out a circuit is because you might have overloaded it. For example, if your house happens to be an old building with most of the wiring being outdated – then chances are that the old wires cannot handle the higher load. And naturally, this would cause a short circuit and blow out the fuse. And that’s why it is always good to call in an electrician in Henderson to handle it.
But if you are still determined to handle it on your own, make sure that you wear thick rubber soles and thick gloves as you attempt to find out what’s wrong. A short circuit can happen for various reasons, stemming from old wiring to being unable to handle the heavy electrical load. If you find that the issue was mainly due to the electrical load, you can ask the local electrician to fix the wire. And unplug other appliances when using this one so that the electrical load is considerably less. But as mentioned, a short circuit can happen due to various reasons and one that you need to get checked out at the earliest.
Take preventive measures
Unless you have adequate know-how on handling electrical issues, it is NOT advisable to tinker with the wires, the fuses, or anything else related to it. But if you have the requisite know-how to proceed, make sure that you wear adequate safe clothing, thick shoes, and gloves. And for obvious reasons, it is not advisable to stand on a damp spot or any water when tinkering with the electrical wiring.
A better option would be to turn off the power first before proceeding. You can at least turn off the power and then look at the fuses and the wiring to see if anything’s scorched. And that’s usually an indication of where the short circuit had happened and would usually indicate where you would need to check out first. Remember, if the wiring is old, the extra load flowing through the wire can cause the circuit breaker to step in and shut it down, causing the fuse to blow up. A simple remedy would be to replace the fuses and if required, the electrical wiring, and it should be as good as new.
Short circuit
When it comes to a short circuit, it certainly seems like the process is quite easy, and all that is required would be for you to replace the fuse. But it is not that easy; for starters, you need to identify the location and determine if it is just a blown-out fuse that you need to replace. Then, you would have to turn off the power first, replace the fuse and turn it back on again. If the fuse blows out again, the short circuit is either due to the old wiring or the light switches.
And that’s why you need to repeat the process. Only this time around, you try to identify the scorch marks, which should often indicate the source of the short circuit. If the scorch marks are on and near the wiring, then you need to get the old ones replaced. And it should work as well. But if the fuses blow out again, then the short circuit has to be with the switches, and you would need to check them out, one by one. And this should enable you to root out the problem and resolve it at the earliest.
And this is how you go about when it comes to handling short circuits and overloaded wires.
